TropiClear pH Minus


	Enlarge Image

TropiClear pH Minus

Description: Safely lowers pH of pool water when used as directed. A good pH test kit is required for use of this product.

Packaging: Bag & Bucket

Weight: 5 & 10 lbs.

Dosage: Before adding pH Minus, predissolve by mixing with water in a clean plastic container. Broadcast pH Minus over the deepest part of the pool.

Ideally, pH should be tested daily. When test kit shows a reading above 7.8, follow the dosage chart below.

Pool Volume (gallons)	pH 7.8 - 8.0	pH 8.0 - 8.4	pH above 8.4
2,500	1 oz.	2 oz.	3 oz.
5,000	2 oz.	4 oz.	6 oz.
10,000	4 oz.	8 oz.	12 oz.
20,000	8 oz.	16 oz.	24 oz.

TropiClear Swimming Pool and Spa Balancing Chemicals

	pH Plus Description: pH Plus raises pH levels to prevent corrosion and eye/skin irritation. Protects expensive equipment. Contains sodium carbonate “soda ash”. Read More
	pH Minus Description: Safely lowers pH of pool water when used as directed. A good pH test kit is required for use of this product. Read More
	Calcium Hardness Description: This product is used to raise calcium hardness in swimming pool water. Low calcium hardness causes pool water to be corrosive and may result in staining, etching or distorting of the pool's finish. Read More
	Alkalinity Control Description: It is important to keep your pool water in balance to get the most effective use of your chemicals. Test daily to ensure that pH, total alkalinity, calcium hardness and cyanuric acid (stabilizer) are within the correct levels. Read More
	Conditioner Description: Conditioner will help maintain a continuous chlorine residual by preventing the breakdown of active chlorine due to the effects of sun, heat and other adverse effects. Read More

TropiClear Conditioner


	Enlarge Image

TropiClear Conditioner

Description: TropiClear Conditioner slows the breakdown of active chlorine due to the effects of sun, heat and other adverse effects. Conditioner will help maintain a continuous chlorine residual and is effective for both liquid and dry types of chlorine sanitizers.

Packaging: Bag & Bucket

Weight: 4, 5, 10, 50 & 100 lbs.

Dosage: Predissolve the required amount of Conditioner (dosage chart below) in a bucket of hot water and stir. Conditioner is a slow dissolving product that is to be poured around the pools perimeter.

Pool Volume	Dosage
500 - 1,000 gallons	0.25 - 0.5 lbs
5,000 gallons	1.25 - 1.5 lbs.
10,000 gallons	2.5 - 3.0 lbs
20,000 gallons	5 lbs
40,000 gallons	10 lbs

TropiClear Alkalinity Control


	Enlarge Image

TropiClear Alkalinity Control

Description: It is important to keep your pool water in balance to get the most effective use of your chemicals. Test daily to ensure that pH, total alkalinity, calcium hardness and cyanuric acid (stabilizer) are within the correct levels.

Packaging: Bag & Bucket

Weight: 5 & 10lbs.

Dosage: As a general rule, 1.5lbs. of Alkalinity Control per 10,000 gallons of water will raise alkalinity by 10 ppm. Make certain circulation equipment is operating before adding Alkalinity Control. Allow water to recirculate for two to three hours and retest for pH and total alkalinity. Repeat treatment until range of 100 - 500 ppm is reached for concrete pools and 125 - 150 ppm for vinyl or fiberglass pools.

Pool Capacity	10 ppm	20 ppm	30 ppm	40 ppm
5,000	1 lb.	2 lb.	3 lb.	4 lb.
10,000	1.5 lb.	3 lb.	4.5 lb.	6 lb.
20,000	3 lb.	6 lb.	9 lb.	12 lb.
30,000	4.5 lb.	9 lb.	12 lb.	18 lb.

TropiClear Calcium Hardness Treatment


	Enlarge Image

TropiClear Calcium Hardness Treatment

Description: This product is used to raise calcium hardness in swimming pool water. Low calcium hardness causes pool water to be corrosive and may result in staining, etching or distorting of the pool's finish. Plaster etched by low calcium hardness will become abrasive and uncomfortable for swimmers. Rough plaster increases algae problems and makes cleaning more difficult.

Packaging: Bag & Bucket

Weight: 4 & 10 lbs.

Dosage: Calcium hardness in pool water should be maintained in the 225-300 ppm range. Never allow calcium hardness to remain below 100 ppm. As a general rule, the addition of 6lbs. per 10,000 gallons of water will raise calcium hardness approximately 50 ppm.

Add TropiClear Calcium Hardness directly to pool water by scattering it over a large area. Do not pre-dissolve this treatment as heat is generated when this product contacts water. Use a surface compatible brush to brush away un-dissolved granules off pool surfaces.

Pool Capacity	Pounds Required To Raise Calcium Hardness
(gallons)	10 ppm	30 ppm	50 ppm	100 ppm	150 ppm	200 ppm
10,000	1.25	3.75	6.25	12.5	19	25
15,000	1.75	5.5	9.5	18	29	36
20,000	2.5	7.5	12.5	25	38	50
25,000	3.25	10	16	32	48	64
30,000	3.5	11	19	36	58	72
40,000	5	15	25	50	72	100
50,000	6.25	19	32	64	96	128

TropiClear pH Plus


	Enlarge Image

TropiClear pH Plus

Description: pH Plus raises pH levels to prevent corrosion and eye/skin irritation. Protects expensive equipment. Contains sodium carbonate “soda ash”.

Packaging: Bag & Bucket

Weight: 5 & 10 lbs.

Dosage: To raise pH, distribute 1 lb. per 10,000 gallons of water while walking around the perimeter of the pool. Allow water to recirculate two to three hours, recheck pH, and repeat treatment as necessary to reach a pH level of 7.4 - 7.6.

Do not add more than 4lbs of pH Plus per 10,000 gallons of water at any one time.

Balancing Chemicals

Correct water balance provides the ideal conditions for bather comfort, effective pool maintenance and best value use of sanitizer and cleansing products. TropiClear has a range of easy to use products, available in a variety of container sizes, for maintaining the correct levels of pH, Total Alkalinity and Calcium Hardness.